Select Page

Help Request for Layout Lighting

Help Request for Layout Lighting

I hope that someone out there with experience of lighting set ups on model railway layouts would be able to assist me with a query.

I have purchased a LIGHT HUB By Woodland Scenics – Code: WJP5701 to power the lights on my layout but am unable to get these lights to work through this hub.

Please can you advise whether this light hub should work with these lights which have the following specifications (pics of both the light hub & lights are attached):-

– Operating Voltage: 3V, AC or DC Compatible.
– Operating Current: 20mA.

I have been told that I may need to use resistors as the volt supply from the Light Hub could be too high, any help you are able to provide would be gratefully appreciated. I have no experience of using resistors and which or how any resistots may need to be used.

Thank you in anticipation of any assistance that anyone is able to offer.

Print Friendly, PDF & Email

About The Author

2 Comments

  1. Holls

    If the unit has a 3v output, you aren’t going to need ‘dropper’ resistors in the circuits. Silly question, but are the dimmers turn up?

    • Holls

      Another thought, are the lights LEDs or filament (light bulbs)?
      If they are 12 volt filaments (and especially if you are wiring 2 or more in series), the 3V unit will not have a large enough output to operate them.
      If the lights are LEDs, they are polarity conscious and need to be wired correctly. If the polarity is cross-connected, they will not light.
      How many are you hoping to wire, and in what configuration (series or parallel. GOOGLE Series and Parallel connection)?
      Assuming that your wiring is as I’ve tried to describe, then either the wall power supply or the unit itself may be knackered.

Leave a reply

Become A VIP Today!

Translate