Select Page

Fitting a DCC decoder to a Hornby 0-6-0 Terrier

Graham from Lakeside showing how to fit a DCC decoder in to a Hornby Terrier Steam loco
Print Friendly, PDF & Email

About The Author

Justin

Favourite Scale: OO / 1:76 Likes: Making small stuff on the laser cutter Dislikes: Counting rivets Other info: Starting to dabble with the world of 3D printing a bit to enhance the products we create on the laser. Layout: Whitwick Grove

1 Comment

  1. PACtrain

    Hi a good solution – possible problem with cooling of chip and or motor if you run the locomotive for extended periods of time (say at an exhibition). Another solution is to put the chip in the coal bunker run the wires across cab floor and colour wire with black permanent marker where it crosses the cab floor. Standard Horny chip (£16 ish) it does the job and is an exact fit.

Leave a reply

Become A VIP Today!

Translate